Little question.
channel 1 clear
Does not reset mixersettings like fill/transform and opacity.
Is this intended behaviour? Or should i concider this as a bug.
I need to reset the server to the same “virgin” state as if it was started. Without nowing it’s actual state, without killing it.
thanks
That is correct. There is a mixer clear command, that you can use for that.
ok check thanks.
then i need to build something for it.
grt
The good thing about having two commands is, that you can setup a complex mixer effect and then clear the visual output, without destroying the mixer effect.
To reset everything, just send the two commands after each other.
CLEAR 1
MIXER 1 CLEAR